Discussion Forum for Technical questions only.
Do they all have the same motor mounts?
Just curious. Personally, I used strut compressors on each spring and removed them, placed the spacer up there and then replaced the spring and...
How much leaf spring arch and length is needed to do a spring over on a TJ wrangler to keep it at 4" of lift?
:twisted: Pictures of 33x12.50 destination mts on my bros short bed manche soon to follow:rock2:
Lady friend bought an XJ today and she wants it lifted, stat. Only money for a budget boost right now, (2" coils in the front), and debating what...
I have a '90 4.2L wrangler, anyone know if plug wires for the 4.0 will work on the 4.2 length wise? I'm upgrading to an HEI setup and they only offer...
What are the best shocks you know. i was thinking Bilsteins or Old Man Emu. Help a brother out
Its about 1"by 2" and the metal is thin around it. It also rusted from the inside out so i gotta dig deep either way.So what should i do ...
. . . . . . . .
Anybody seen any threads about swapping a C8.25" in the Wrangler? I looked, but couldn't find anything. :( I know, "get a Ford 8.8". I want to do...
http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=95912 How would it do for dead rolling pulls up onto a car trailer. Should be...
im not sure on how large of a lift you can go on a stock driveshaft, but im going to be getting the 5.5 critical path longarm kit for my zj. am i...
Where is the cheapest place to get some harness seats? just want some bucket seats with 4 point harnesses... cheapest i can really find is jegs at...
Best to put sleve tube over the outside, or sleeve it on the inside to lengthen one two inches?
Ok, what it comes down to is my Nissan gettings tons is getting scrapped as a project as a whole. Spring time came two months early this year, and...
So it goes like this. 4'' Coils all the way around, 1.75'' leveling spacers up front. Steering is extremely toed it, I go to take it aligned. Tire...
anyone know how to strip anodizing in a DIY matter?
Well, I am about to do some ring and pinion work to my jeep. 4.88s. I am trying to decide what I want locker wise. Well, I know I would love to...
Going to 4.88s soon. Basically, only can afford to do the rear right now. As long as I dont use 4x4, will I hurt anything just doing the back for...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
